Beli Tail Stock Mesin Bubut di monotaro.id

This fixture has six phase,fixed on tail-stock of lathe,It is easy to operation and high precision,with six abilities such as drilling,tapping, reaming,drilling center hole and centerThe attachmebnts are applicable to F3 drill-tap fixture,during the using course,You can install them according to your procedure,the collet of reaming is purchased specially

Mata bor ini biasa digunakan pada mesin bubut yang berfungsi untuk membuat lubang senter di bagian ujung permukaan benda yang sedang dikerjakan. Terdapat 6 ukuran yang bisa Anda pilih sesuai keinginan dan kebutuhan. Terbuat dari material berkualitas yang dijamin kuat dan awet untuk penggunaan jangka panjang

Manufactured from high alloy steel hardened and tempered then precision ground externally. Precision bearings are fitted as standard and the centres have a 60 Degree point. Mounting Tapers are accurate to DIN228 Form A, Tolerance Class AT5. Maximum runout: No.1 to 4 taper: 0.005mm. No.5 to 6 taper: 0.010mm.

-With a carbide tip.-Prevent vibration of workpieces.

Center in made of SCM420 alloy steel by heat treatment to provide higher rigidity (HRC60±2 degrees) and satisfied wear-resistance.Center is constituted by ball bearings assembly.Applicable to middle-speed & high-speed lathe with light load.

Head Driving With Unique Mechanism. With Larger Nose For Use On Normal, Pipe, and Hollow Pieces Centering.

-Cutting oil and water intrusion is prevented by its own structure adopted by the SUNFLON Seal. Optimum for dry cutting as well as wet cutting of NC lathes.-Mainly to prevent and support shaking of long workpieces.

Head Driving With Unique Mechanism. For Use On N/C Lathes And Traced Control.

-It adopts a unique head driving mechanism(center and integrated head)-It shuts out dust and cutting water from entering 100% and maintains high accuracy.-For wet cutting of NC lathes.